2 - 40 WiNG CLI Reference Guide
2.1.21 show
User Exec Commands
Displays the settings for the specified system component. There are a number of ways to invoke the show command:
• When invoked without any arguments, it displays information about the current context. If the current context contains
instances, the show command (usually) displays a list of these instances
• When invoked with the display_parameter, it displays information about that component.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
show <parameter>
Parameters
Example
rfs7000-37FABE>show ?
adoption Display information related to adoption to wireless
controller
advanced-wips Advanced WIPS
captive-portal Captive portal commands
cdp Cisco Discovery Protocol
clock Display system clock
cluster Cluster Protocol
commands Show command lists
context Information about current context
critical-resources Critical Resources
crypto Encryption related commands
debug Debugging functions
debugging Debugging functions
device-categorization Device Categorization
event-history Display event history
firewall Wireless Firewall
interface Interface Configuration/Statistics commands
ip Internet Protocol (IP)
licenses Show installed licenses and usage
mac-address-table Display MAC address table
mint MiNT protocol
noc Noc-level information
ntp Network time protocol
password-encryption Pasword encryption
power Show power over ethernet command
remote-debug Show details of remote debug sessions
rf-domain-manager Show RF Domain Manager selection details
NOTE:
NOTE: Refer to ‘Chapter 6, SHOW COMMANDS’ for more information.
Comments to this Manuals