PROFILES 7 - 49
nat [inside|outside][destination
static <A.B.C.D>
[<1-65535>[[tcp |udp]
<A.B.C.D> {1-
65535>}]|<A.B.C.D>
{1-65535}]|source [list <IP-
ACCESS-LIST> interface vlan
<1-4094> [<A.B.C.D>
overload|overload]|static
<A.B.C.D> <A.B.C.D>]
Network Address Translation (NAT)
• inside – Inside address translation
• outside – Outside address translation
The following parameters are the same for both inside and outside NAT
parameters:
• destination static – Specifies the destination address translation to
configure
• static <A.B.C.D> – Specifies the static NAT mapping
• <A.B.C.D> [<1-65535>|<A.B.C.D>] – Specifies the IP
address (A.B.C.D) to configure
• <1-65535> [tcp|udp] – Select a value between 1 and 65535
to configure as an actual outside port
• tcp – Transmission control protocol
• udp – User datatgram protocol
The following parameters are common for both TCP and UDP:
• <A.B.C.D> {<1-65535>} – Specifies the outside natted IP
address (A.B.C.D) to configure
• <1-65535> – Select a value between 1 and 65535 to
configure outside natted port
• A.B.C.D> <1-65535> – Specifies the outside natted IP
address (A.B.C.D)
• <1-65535> – Select a value between 1 and 65535 to
configure outside natted Port
• source – Specifies the source address translation to configure
• list <IP-ACCESS-LIST> – Specifies the access list describing lo-
cal addresses
• <IP-ACCESS-LIST> interface – Specifies the access list name
• interface vlan – Select an Interface to configure
• vlan <1-4094> – Select a VLAN interface (switched virtual
interface) to configure
• <1-4094> [address <A.B.C.D> overload|overload|pool] –
Select a VLAN ID between 1 and 4094 to configure the
interface
• address <A.B.C.D> overload – Specifies an interface IP
address used for NAT
• overload – Enables the use of one global address for
numerous local addresses.
• pool <NAT-POOL> overload – Sets the NAT pool
• <NAT-POOL> – Specifies the NAT pool
• static [<A.B.C.D> |<A.B.C.D> – Specifies the static
local-global mapping
• <A.B.C.D> – Specifies the inside actual IP address (A.B.C.D)
to configure
• A.B.C.D> – Specifies the natted IP address (A.B.C.D) to
configure
• pool <NAT-POOL> – IP address pool for NAT
Comments to this Manuals