CHAPTER 14 FIREWALL-POLICY
This chapter summarizes the firewall-policy commands within the CLI structure.
Use (config) instance to configure firewall-policy related configuration commands. To navigate to the
config-fw-policy instance, use the following commands.
rfs7000-37FABE(config)#firewall-policy <policy-name>
rfs7000-37FABE(config)#firewall-policy test
rfs7000-37FABE(config-fw-policy-test)#?
Firewall policy Mode commands:
alg Enable ALG
clamp Clamp value
dhcp-offer-convert Enable conversion of broadcast dhcp offers to
unicast
dns-snoop DNS Snooping
firewall Wireless firewall
flow Firewall flow
ip Internet Protocol (IP)
ip-mac Action based on ip-mac table
logging Firewall enhanced logging
no Negate a command or set its defaults
proxy-arp Enable generation of ARP responses on behalf
of another device
stateful-packet-inspection-l2 Enable stateful packet inspection in layer2
firewall
storm-control Storm-control
virtual-defragmentation Enable virtual defragmentation for IPv4
packets (recommended for proper functioning
of firewall)
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or
terminal
rfs7000-37FABE(config-fw-policy-test)#
Comments to this Manuals