13 - 24 WiNG CLI Reference Guide
13.1.5 static-binding-mode
Use the (config) instance to configure dhcp-static-binding related configuration commands. To
navigate to the instance, use the following commands:
rrfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#static-binding client-
identifier Hex
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1-binding-Hex)#?
Table 13.3 Summarizes static-binding-mode commands
Table 13.3 static-binding Commands
Command Description Reference
bootfile Assigns a bootfile name for the DHCP
configuration on the network pool
page 13-25
client-name Specifies a client-name to configure page 13-26
default-router Configures default-router or gateway IP address
for the network pool
page 13-27
dns-server Sets the DNS server’s IP address available to all
DHCP clients connected to the DHCP pool
page 13-28
domain-name Sets the domain name for the network pool page 13-29
ip-address Configures a fixed IP address for a host page 13-30
netbios-name-server Configures a NetBIOS (WINS) name server IP
address
page 13-31
netbios-node-type Defines the NetBIOS node type page 13-32
next-server Configures the next-server in the boot process page 13-33
no Negates a command or sets its default value page 13-34
option Configures raw DHCP options page 13-35
respond-via-unicast Sends a DHCP offer and DHCP Ack as unicast
messages
page 13-20
static-route Adds static routes to be installed on DHCP clients page 13-37
Comments to this Manuals