PROFILES 7 - 115
7.2 Device Specific Commands
Use the (config) instance to configure device specific parameters.
To navigate to this instance, use the following commands:
rfs7000-37FABE(config)#ap7131?
rfs7000-37FABE(config)#ap7131 00-15-70-88-9E-C4
rfs7000-37FABE(config-device-00-15-70-88-9E-C4)#
Table 7.9 Summarizes Device Mode commands
Table 7.9 Device Mode Commands
Command Description Reference
ap-upgrade Upgrades AP firmware page 7-117
area Sets the name of area where the
system is located
page 7-118
contact Sets contact information page 7-119
country-code Configures the controller country
code
page 7-120
dhcp-redundancy Enables DHCP redundancy page 7-121
floor Sets the name of a floor within a
building where the system is
deployed
page 7-122
hostname Sets a system's network name page 7-123
layout-coordinates Configures layout coordinates page 7-124
location Configures the location the
system is deployed
page 7-125
mac-name Configures MAC name to name
mappings
page 7-126
neighbor-info-interval Configures the neighbor
information exchange interval
page 7-127
override-wlan Configures RF Domain level
overrides for a WLAN
page 7-128
remove-override Removes overrides from a device page 7-129
rsa-key Assigns a RSA key to SSH page 7-130
sensor-server Configures a AirDefense sensor
server
page 7-131
stats Configures statistics stettings page 7-132
timezone Configures controller timezone
settings
page 7-133
Comments to this Manuals