3 - 12 WiNG CLI Reference Guide
3.1.6 clear
Privileged Exec Mode Commands
Clears parameters, cache entries, table entries, and other similar entries. The clear command is only available for specific
commands. The information cleared using this command varies depending on the mode where the clear command is
executed.
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
clear [arp-cache|cdp|counters|crypto|event-history|firewall|ip|lldp|
spanning-tree]
clear arp-cache {on <DEVICE-NAME>}
clear [cdp|lldp] neighbors {on <DEVICE-NAME>}
clear crypto [ipsec|isakmp] sa [<IP>|all] {on <DEVICE-NAME>}
clear event-history
clear firewall [dhcp snoop-table|dos stats|flows] {on <DEVICE-NAME>}
clear ip dhcp bindings [<A.B.C.D>|all] {on <DEVICE-NAME>}
clear spanning-tree detected-protocols {interface {<INTERFACE>|
ge <1-8>|me1|port-channel <1-4>|vlan <1-4094>} {on <DEVICE-NAME>}
clear counters [all|bridge|router|thread]
clear counters interface [<INTERFACE>|all|ge <1-8>|me1|
port-channel <1-4>|vlan <1-4094>]
NOTE: Refer to the interface details below when using clear
• ge <index> – RFS4000 supports 4GEs and RFS6000 supports 8 GEs
• me1– Available in both RFS7000 and RFS6000
Comments to this Manuals