7 - 22 WiNG CLI Reference Guide
7.1.8 cluster
Creating Profiles
Sets the cluster configuration
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
cluster [auto-revert|auto-revert-delay|handle-stp|member|mode|name]
cluser member [ip <A.B.C.D>|vlan <1-4094>]
cluster mode [active|standby]
cluster name <WORD>
Parameters
Example
rfs7000-37FABE(config-profile-default-rfs7000)#cluster name cluster1
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#cluster member ip 172.16.10.3
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#cluster mode active
rfs7000-37FABE(config-profile-default-rfs7000)#
rfs7000-37FABE(config-profile-default-rfs7000)#show context
profile rfs7000 default-rfs7000
bridge vlan 1
description Vlan1
.............................................
auto-revert Enables auto-revert
auto-revert-delay
<1-1800>
Configures auto-revert-delay between 1 and 1800 minutes
handle-stp Configures STP convergence
member [ip <A.B.C.D>|vlan
<1-4094>]
Adds a cluster member
• ip <A.B.C.D> – Sets the IP address of the cluster member
• <A.B.C.D> – Specifies the IP address to configure
• vlan <1-4094> – Sets the VLAN on which cluster members are
reachable
• <1-4094> – Specifies the VLAN index between 1- 4094
mode [active|standby] Configures the cluster mode as either active or standby
•active – Active mode
• standby – Standby mode
name <WORD> Configures cluster name
Comments to this Manuals