20 - 14 WiNG CLI Reference Guide
20.1.3.9 use
user-role
Defines the settings used with the user role
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
use [ip-access-list|mac-access-list]
use ip-access-list [in|out] <IP-ACCESS-LIST> precedence
<1-100>
use mac-access-list [in|out] <MAC-ACCESS-LIST> precedence <1-100>
Parameters
Example
rfs7000-37FABE(config-role-role1)#use ip-access-list in test precedence 9
rfs7000-37FABE(config-role-role1)#
ip-access-list [in|out] <IP-
ACCESS-LIST> precedence
<1-100>
Uses an IP access list
• in – Applies the rule to incoming packets
• out – Applies the rule to outgoing packets
The following parameters are common for the above:
• <IP-ACCESS-LIST> – Specifies the access list name
• precedence – Based on the packets received, the lower
precedence value is evaluated first
• <1-100> – Specifies the precedence value between 1 and
100
mac-access-list [in|out] <MAC-
ACCESS-LIST> precedence <1-
100>
Uses a MAC access list
• in – Applies the rule to incoming packets
• out – Applies the rule to outgoing packets
The following parameters are common for the above:
• <MAC-ACCESS-LIST> – Specifies the access list name
• precedence – Based on the packets received, the lower
precedence value is evaluated first
• <1-100> – Specifies the precedence value is from 1 -100
NOTE: The commands no, write, clrscr, commit, exit, help, show, service are common
commands. For more information, see Chapter 5, COMMON COMMANDS.
Comments to this Manuals