PROFILES 7 - 51
7.1.19 nat-pool
Creating Profiles
Use this (config-profile-default-rfs7000) instance to configure NAT pool commands.
rfs7000-37FABE(config-profile-default-rfs7000)#ip nat pool pool1 prefix-length
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#ip nat pool pool1
prefix-length 1
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)#?
Nat Policy Mode commands:
address Specify addresses for the nat pool
no Negate a command or set its defaults
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-profile-default-rfs7000-nat-pool-pool1)
Table 7.6 Summarizes nat-pool commands
Table 7.6 nat-pool Commands
Command Description Reference
address Specifies addresses for the NAT pool page 7-52
no Negates a command or sets its default page 7-53
Comments to this Manuals