4 - 118 WiNG CLI Reference Guide
4.1.46.2.5acl
wlan-mode commands
Defines the actions taken based on an ACL rule configuration
Supported in the following platforms:
• RFS7000
• RFS6000
• RFS4000
• AP71xx
• AP650
• AP6511
• AP6532
Syntax
acl exceed-rate wireless-client-denied-traffic <0-1000000> {blacklist
<0-86400>|disassociate}
Parameters
Example
rfs7000-37FABE(config-wlan-1)#acl exceed-rate wireless-client-denied-traffic 20
disassociate
rfs7000-37FABE(config-wlan-1)#show context
wlan 1
ssid WLAN_USECASE_01
vlan 2
bridging-mode tunnel
encryption-type none
authentication-type none
acl exceed-rate wireless-client-denied-traffic 20 disassociate
exceed-rate wireless-client-
denied-traffic
<0-1000000> {blacklist
<0-86400> |disassociate}
Sets the actions taken based on an ACL rule configuration
• exceed-rate – Action is taken when the rate exceeds a set value
• wireless-client-traffic <0-1000000> – The action is to deny traffic to the
client
• <0-1000000> – Sets the packet data
• blacklist <0-86400> – Optional. Sets the time to blacklist a wireless
client
• disassociate – When enabled, a client is disassociated
Comments to this Manuals