Task 4: Installing license keys Chapter 6 Configuration and alignment
phn-1115_006v000
6-14
Sep 2010
Task 4: Installing license keys
This task consists of the following procedures:
• Checking licensed capabilities on
page 6-14
• Generating a new license key on pa
ge 6-16
• Entering a new license key on pa
ge 6-16
Some PTP 300 and PTP 500 products are supplied with two license keys: one installed
at the factory and one alternative key.
Checking licensed capabilities
To check that the capabilities of the installed license key meet the operator’s
requirements, proceed as follows:
Procedure 6-6 Check capability summary
1
Select menu option System, License Key. The Software License Key
page is displayed (Figure 6-11).
2
Check the attributes in the Capability summary section (Table 6-3), in
partic
ular:
Region Code must be correct.
If encryption is required, ensure that the Encryption Algorithm
setting is correct.
3
If the region code in the installed license key is incorrect, install the
alternative license key as described in Entering a new license key on
page
6-16 and check its capabilities.
4
If the available license keys do not have the required capabilities, then
determine the new requirements and refer to Generating a new license
key on pa
ge 6-16.
Comments to this Manuals