Motorola PTP 500 User's Guide Page 315

  • Download
  • Add to my manuals
  • Print
  • Page
    / 447
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 314
PTP 300 and PTP 500 Series User Guide Task 8: Configuring wireless and telecoms interfaces
phn-1115_006v000
Sep 2010
6-33
The contents of the Wireless Configuration page vary depending upon the options
selected as follows:
If Spectrum Management Control is set to ‘Fixed Frequency’, the Lower Center
Frequency field is replaced by Fixed Tx Frequency and Fixed Rx Frequency.
If Platform Variant is set to ‘Connectorized’, Antenna Gain and Cable Loss are
also displayed.
Table 6-5 Step 2: Wireless Configuration attributes
Attribute Meaning
Access Method This attribute controls how the unit identifies and connects to
the correct peer unit. There are two methods:
‘Link Access’ means that each unit must be configured with a
Target MAC Address equal to the actual MAC address of its
peer.
‘Link Name Access’ means that both units must be configured
with the same Link Name.
Link Name Only displayed when Access Method is set to ‘Link Name
Access’. A link can only be established between units that
have identical Link Names.
Link Name may consist of letters (A-Z and a-z), numbers
(0-9), spaces, and the following special characters:
(),-.,:<=>[]_{}
Target MAC
Address
This is only displayed when Access Method is set to ‘Link
Access’. This is the MAC Address of the peer unit that will be
at the other end of the wireless link. This is used by the
system to ensure the unit establishes a wireless link to the
correct peer. The MAC Address can be found embedded
within the serial number of the unit. The last six characters of
the serial number are the last three bytes of the unit’s MAC
address.
NOTE
A PTP 300 or PTP 500 Series system is shipped as a pair
of units with pre-loaded correct MAC addresses. Target
MAC addresses will only need to be entered if an existing
unit has to be replaced in the field or the units
configuration has been erased.
Page view 314
1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 446 447

Comments to this Manuals

No comments