Using recovery mode Chapter 7 Operation
phn-1115_006v000
7-56
Sep 2010
Upgrading software image
To restore a working software image from the Recovery Options page (Figure 7-24),
proceed as follows:
Procedure 7-11 Upgrade software image when in recovery mode
1
Select Browse.
2
Navigate to the required software image. This may be the most recent image
if software corruption is suspected, or an older image if an incorrect image
has just been loaded. Click on the image and select OK.
3
Select Upgrade Software Image. The Upgrade Progress Tracker page is
displayed (Figure 7-25).
4
When the Software Upgrade Complete page is displayed (Figure 7-26), check
that th
e correct image has been downloaded.
5
Select Reboot Wireless Unit. When the ‘Are you sure?’ pop up box is
displayed, select OK.
6
The unit will now reboot. The unit should restart in normal operational mode
and the link should recover. If the unit or link fails to recover, refer to
Testing link end hardware on
page 8-2.
Figure 7-25 Upgrade Progress Tracker page
Figure 7-26 Software Upgrade Complete page
Comments to this Manuals