Preparing and using drop cable Chapter 5 Installation
phn-1115_006v000
5-12
Sep 2010
7
Repeat with a further four layers of PVC tape.
Start the second layer 25mm (1 inch) above the first layer tape, start the
third layer below the finish of the second layer. Continue until five layers
have been applied, always over lapping at half width.
8
If a single hole tag is required at the mast end, modify the two hole tag as
shown.
9
Apply the anti-oxidant compound liberally applied between the two metals.
If paint is present, remove it to provide a good electrical contact.
Comments to this Manuals