Motorola PTP 500 User's Guide download pdf (Page 224)

Notifications Chapter 4 Reference information

phn-1115_006v000

4-72

Sep 2010

Notifications

The PTP 300 and PTP 500 comply with the regulations that are in force in the USA,

Canada and Europe. The relevant notifications are specified in this section.

PTP 54300 and PTP 54500 FCC and IC notification

U.S. Federal Communication Commission (FCC) and Industry Canada (IC) Notification.

This device complies with part 15.407 of the US FCC Rules and Regulations and with

RSS-210 Issue 7 of Industry Canada. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause

undesired operation. In Canada, users should be cautioned to take note that high

power radars are allocated as primary users (meaning they have priority) of the

5250 – 5350 MHz and 5470 – 5725 MHz and these radars could cause interference

and/or damage to license-exempt local area networks (LELAN).

For the connectorized version of the product and in order to reduce potential radio

interference to other users, the antenna type and its gain should be so chosen that the

equivalent isotropically radiated power (EIRP) is not more than that permitted by the

regulations. The transmitted power must be reduced to achieve this requirement.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the US FCC Rules and with RSS-210 of Industry

Canada. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can

radiate radio-frequency energy and, if not installed and used in accordance with these

instructions, may cause harmful interference to radio communications. If this

equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment on and off, the user is encouraged to correct

the interference by one or more of the following measures:

• Increase the separation between the affected equipment and the unit;

• Connect the affected equipment to a power outlet on a different circuit from that

which the receiver is connected to;

• Consult the dealer and/or experienced radio/TV technician for help.

• FCC IDs and Industry Canada Certification Numbers are listed below:

1 ... 223 224 225 ... 447

No comments

Motorola PTP 500 User's Guide Page 224