Task 8: Configuring wireless and telecoms interfaces Chapter 6 Configuration and alignment
phn-1115_006v000
6-26
Sep 2010
Task 8: Configuring wireless and telecoms interfaces
The wireless and telecoms interfaces are configured using the installation wizard. The
installation wizard may also be used to re-configure the Ethernet interface if required.
This task consists of the following procedures:
• Starting installation wizard on pa
ge 6-26
• Step 1: Interface configuration on
page 6-28
• Step 2: Wireless configuration on
page 6-31
• Step 3: TDD synchronization (optional) on page 6-39
• Step 3 or 4: Con
firm installation configuration on pa
ge 6-41
Starting installation wizard
To check that the wireless configuration meets network requirements, select menu
option Installation. The response depends upon the state of the unit:
• If the unit is armed for alignment (factory default configuration), the Disarm
Installation page is displayed (Figure 6-23).
• If the unit is not
armed, the
Current Installation Summary page (Figure 6-24) is
displayed.
Revi
ew the configuration:
• If it already meets requirements, skip this task and go to Task 10: Aligning
an
tennas on page 6-44.
• If it does not meet r
equirements, execute the installation wizard by one of the
following methods:
o From the Disarm Installation page (Figure 6-23), select Ba
ck.
o From t
he Current Installation Summary page (Figure 6-24), select
Continue to
Installlation Wizard.
Comments to this Manuals