Motorola PTP 500 User's Guide Page 62

  • Download
  • Add to my manuals
  • Print
  • Page
    / 447
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 61
Wireless operation Chapter 1 Product description
phn-1115_006v000
1-22
Sep 2010
Adaptive: The capacity allocated to a given link direction is dependant on the
offered level of network traffic in both link directions. If the level of offered
traffic in both directions is equally high or equally low, the system will allocate
equal capacity to both directions. If however the offered level of traffic is greater
in one direction, it is allocated a greater proportion of the overall link capacity.
The system achieves this by increasing (or decreasing) the duration of the
Transmit Burst in a given link direction as the offered level of network traffic
increases (or decreases) in this same direction. This is done independently for
the two directions.
NOTE
Adaptive mode is not available in the following configurations :
o When link mode optimization is set to TDM Traffic see Link mode
optimizati
on on
page 1-21).
o When T
DD synchronization is enabled.
o In regions where radar avoidance is operational (see Radar avoidance on
pag
e
1-27).
o When 5 MHz bandwi
dth is selected.
Non Line Of Sight (NLOS) and Line Of Sight (LOS)
PTP 300
The PTP 300 Series Bridge is designed to operate by default in both Non Line Of Sight
(NLOS) and Line Of Sight (LOS) environments. However, the PTP 300 web interface
includes a Line Of Sight mode control. When this control is enabled, the bridge can
operate at higher data throughput rates over a short unobstructed path.
LOS mode is available only where license key enables the capability, the mode is
enabled in the Installation Wizard, and the link range is less than 10 km (6.2 miles). A
PTP 300 bridge operating in LOS mode has the same throughput capacity as a PTP
500 Lite bridge.
PTP 500
The PTP 500 Series Bridge is designed to operate in both Non Line Of Sight (NLOS)
and Line Of Sight (LOS) environments. The LOS mode feature is not available in the
PTP 500.
Page view 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 446 447

Comments to this Manuals

No comments