Motorola DSR-4530 Instruction Manual download pdf (Page 59)

DSR-4530 53

Operating the DSR-4530

Diagnostics Menus

The DSR-4530's diagnostic menus allow the user to isolate problems to the DSR-

4530 or the satellite using the front panel. The menus also enable the user to test

waveforms and use other diagnostic information displayed on an NTSC television

monitor connected through the rear-panel video output.

Caution: Turning on diagnostics changes the video or audio output, and these

diagnostic screens or tones may be transmitted to the cable customers if the

receiver is connected to the cable plant.

To access the Diagnostic menus, press ENTER button to return to the main top-level

menu (shown below).

Press the

buttons until the cursor is at the Diag label, and press the ENTER

button. The DSR-4530 displays the first sub-menu within the Diagnostics menus.

Diagnostics Menu

Press the

buttons until the Diagnostics menu appears (shown below).

Menus Field

The Menus field allows the user to enable or disable the on-screen diagnostics to a

video monitor connected to the rear of the IRD.

Note: For more information on the diagnostic screens, refer to"Viewing the Fast

Fact Diagnostic Screens" (described on page 70).

Press the

button until the cursor is at the Menus label, and press the ENTER

button to move into the field. Press the

buttons to scroll to the televised screen

of choice (i.e., Off, Fact 1-5; Diag A-E). Press the ENTER button to confirm the

selection and exit this field.

Note: The Diag A-E are typically used by Motorola with hotline troubleshooting.

E Install Channel IP Status Diag

DSR-4530

E Off

DIAGNOSTIC Menus

E Diag A No

DIAG Menus Clear Cntrs

1 ... 58 59 60 ... 92

No comments

Motorola DSR-4530 Instruction Manual Page 59