Motorola DSR-4530 Instruction Manual download pdf (Page 53)

DSR-4530 47

Operating the DSR-4530

GigE MPTS Address Menu

Use the following procedure to set and view the GigE Single Program Transport

Stream (SPTS) address and port of the destination node for the transport stream

output. The GigE SPTS is an address that is represented in the common dotted-

decimal format. Contact the network administrator for details about configuring the

GigE port for operation on your local network.

Press the

buttons until the GigE MPTS Address menu appears (shown below).

SPTS Address Field

Press the

button until the cursor is at the SPTS Address label, and press the

ENTER button to move into the field. The SPTS Address range is from

000.000.000.000 to 255.255.255.255.

Use the

buttons to select the digit to change and then, while the cursor is on

that digit, press the

buttons to display the desired value. Repeat this process

for each applicable digit to be changed.

Press the ENTER button to confirm the selection and exit the field.

Port Field

Press the

button until the cursor is at the Port label, and press the ENTER button

to move into the field. The Port ID range is from 00000 to 65535.

Use the

buttons to select the digit to change and then, while the cursor is on

that digit, press the

buttons to display the desired value. Repeat this process

for each applicable digit to be changed.

Press the ENTER button to confirm the selection and exit the field.

1 ... 52 53 54 ... 92

No comments

Motorola DSR-4530 Instruction Manual Page 53