Motorola DSR-4530 Instruction Manual Page 56

  • Download
  • Add to my manuals
  • Print
  • Page
    / 92
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 55
3
50
Status4 Menu
Note: This menu is not displayed when the active signal is received from a source
other than an L-band input connector.
Press the
56
buttons until the Status4 menu appears (shown below). This screen
displays the satellite name and signal tuning characteristics and provides mode-
specific information depending upon the acquisition mode selected (i.e., DCII-
AUTO, DCII-MAN, DVB-MAN, etc.).
Sat Field
This field displays the satellite reference name (two to four alphanumeric
characters) from the downloaded network information. Three dashes (---) are
displayed when no information is available.
Freq Field
This field displays the downlink frequency (range: 950.00 - 2150.00 MHz) of the
L-band signal. This may be different from the frequency that was initially set in the
Manual Tune menu. Three dashes (---) are displayed when no information is
available or that the ASI input is in use.
Symb Field
This field displays the symbol. Three dashes (---) indicate that no information is
available or when the ASI input is in use.
Code Field
This field displays the code rate (error control coding for forward error correction)
of the received L-band signal. Three dashes (---) indicate that no information is
available or the ASI input is in use.
E ||||||||||||||||||...................................................
STATUS3 Signal_Quality
E --- --- --- --- ---
STATUS4 Sat Freq Symb Code Format
Read-only
Read-only
Read-only
Read-only
Page view 55
1 ... 55 56 57 ... 92

Comments to this Manuals

No comments