RTLS Instance 21-9
21.1.8 no
RTLS Config Commands
Use this command to negate an RTLS command or set its defaults.
Syntax
no [aeroscout|ekahau|service|site|switch|ap]
Parameters
Usage Guidelines
Use the
no
command to undo the configurations on the parameters mentioned in the table. Refer to the parameters,
within this chapter, for complete syntax.
no aeroscout
[enable|
multicast-listen-addr]
Negates AeroScout configuration.
• enable – Disables the SOLE adapter.
• multicast-listen-addr– Removes configured multicast listening address.
no ekahau
[enable|engine|
multicast-listen-addr]
Negates ekahau configuration.
• enable – Disables aeroscout external engine.
• engine – Resets external location engine parameters.
• multicast-listen-addr – Removes configured multicast listening address.
no service
[filter <1-100>|
rtls [mode]]
Negates RFID tag filter configuration.
• filter <1-100> – Negates RFID tag filter configuration.<1-100>
{length|memory-bank|offset} – Negates RFID tag filter configuration
for the tag specified by <1-100>. This command negates following tag
filter settings:
• length – Optional. Length of tag filter
• memory-bank – Optional. Tag memory bank
• offset – Optional. Offset into the tag memory bank
• rtls [mode] – Negates the RTLS mode setting.
site
[description|
dimension|
name|scale]
Negates following site configurations:
• description – Removes the site description.
• dimension – Removes the site dimensions.
• name – Removes the site name.
• scale – Resets the site scale to default.
ap
[<MAC-ADDRESS>
<COORDINATES>]
Negates access port location coordinates configuration.
• <MAC-ADDRESS> – Specify the access port MAC address in the AA-BB-
CC-DD-EE-FF format.
• <COORDINATES> – Negates AP location configuration.
switch
[coordinates
|geo-coordinates]
Negates following switch configuration parameters:
• coordinates – Negates switch coordinates configuration within the site.
• geo-coordinates – Negates switch geo coordinates configuration.
Comments to this Manuals