Common Commands 2-19
• radio-misc-cfg <LINE> – Sets radio-specific misc configuration U16
for all radios
• <LINE> – The hexadecimal 0000-FFFF bit mask enabling/disabling
various misc configurations
• rate-scale – Enables wireless rate scaling (default)
• request-ap-log <1-1024> – Requests AP logs. Set the AP index
between 1 - 1024
• save-ap-log – Saves a debug/error sent by the access port
• snmp-trap-throttle <1-20> – Limits the number of SNMP traps
generated from the wireless table. Set the maximum number of traps
to be generated per second between 1 - 20.
• sync-radio-entries – Syncs radio configuration entries at cluster level
• vlan-cache (enable) – Enables VLAN cache mode (default)
wireless (custom-cli)
(sh-wi-mobile-unit)
Customizes the output of the “show wireless mobile unit” command. The
options are:
• ap-locn – Displays the location of the AP where this mobile unit is
associated
• ap-name – Name of the AP where the mobile unit is associated
• channel – The channel of the radio where the mobile unit is
associated
• dot11-type – The dot11 radio type of the mobile unit
• ip – The mobile unit’s IP address
• last-heard – The time when a packet was last received from the
mobile unit
• mac – The mobile unit’s MAC address
• radio-bss – The BSSID of the radio where the mobile unit is
associated
• radio-desc – The description of the radio where the mobile unit is
associated
• radio-id – The radio index to which the mobile unit is associated
• ssid – The the mobile unit’s WLAN SSID
• state – The mobile unit’s current state
• vlan – The mobile unit’s VLAN ID
• wlan-desc – The WLAN description the mobile unit is using
• wlan-id – The WLAN index the mobile unit is using
Comments to this Manuals