Standard ACL Instance
Use the
(config-std-nacl)
instance to configure
ip
access-list standard
ACLs. Standard ACLs allow
filtering based on the source address only.
15.1 Standard ACL Config Commands
Table 15.1 summarizes
config-std-nacl
commands.
Table 15.1 Standard ACL Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 15-2
deny Specifies packets to reject. page 15-3
end Ends the current mode and changes to EXEC mode. page 15-4
exit Ends the current mode and moves to the previous mode. page 15-5
help Displays the interactive help system. page 15-6
mark Specifies packets to mark. page 15-7
no Negates a command or set its defaults. page 15-8
permit Specifies packets to forward. page 15-9
service Displays service commands. page 15-10
show Shows the running system information. page 15-11
Comments to this Manuals