Global Configuration Commands 5-61
5.1.33 redundancy
Global Configuration Commands
Use this command to configure redundancy group parameters.
Syntax
redundancy [auto-revert|auto-revert-period|critical-resource-ip|dhcp-server|
discovery-period|dynamic-ap-load-balance|enable|group-id|handle-stp|
heartbeat-period|hold-period|interface-ip|manual-revert|member-ip|mode]
redundancy auto-revert [enable]
redundancy auto-revert-period <1-1800>
redundancy critical-resource-ip <A.B.C.D>
redundancy dhcp-server [enable]
redundancy discovery-period <10-60>
redundancy dynamic-ap-load-balance [enable|per-ap-mu-threshold <1-512>|
schedule-interval <1-366>|schedule-start-time|trigger (runtime|schedule)]
redundancy enable
redundancy group-id <1-65535>
redundancy handle-stp [enable]
redundancy heartbeat-period <1-255>
redundancy hold-period <13-255>
redundancy interface-ip [<A.B.C.D>]
redundancy manual-revert
redundancy member-ip [<A.B.C.D>]
redundancy mode [primary|standby]
Parameters
auto-revert [enable] Enables auto-revert
auto-revert-period
<1-1800>
Sets the redundancy auto-revert delay interval
• <1-1800> – Specify the auto-revert delay intervalbetween 1 - 1800 minutes
(default is 5 minutes).
critical-resource-ip
<A.B.C.D>
Sets the critical resource IP address
• <A.B.C.D> – Specify the e critical resource IP address.
dhcp-server [enable] Enables DHCP redundancy protocol
discovery-period <10-60> Sets the redundancy discovery interval
• <10-60> – Specify the discovery time between 10 -60 seconds (default is 30
seconds).
Comments to this Manuals