20-10 Motorola Solutions RFS7000GR Series RF Switch, CLI Reference Guide
Example
RFS7000(config-wireless)#ap 00-15-70-14-FE-C4 location 5th Floor SalesUnit
RFS7000(config-wireless)#
[ABG-scan|
aap-admin-passwd|
aap-mgmt-vlan|
aap-native-vlan-id|
aap-native-vlan-tag|
adoption-policy|
country-code|
lan-acl|
location|
name|
radio-config]
The following keywords are common to the <1-1024>, <LIST>, and
<MAC-ADDRESS> parameters:
• ABG-scan [enable] – Configures ABG scan mode on the AP.
• enables – Enables detector radios to perform ABG scan.
• aap-admin-passwd <LINE> – Configures the AAP admin password.
• <LINE> – Specify the password (should be between 1 - 11 characters in
length).
• aap-mgmt-vlan [lan1] [<1-4094>] – Configures the AAP management VLAN.
• lan1 <1-4094> – Configures the AAP management VLAN on the LAN1
interface.
• <1-4094> – Configures the management VLAN’s index between
1 - 4094.
• aap-native-vlan-id [lan1] [<1-4094>] – Configures native VLAN ID.
• lan1 – Configures the native VLAN’s ID on the LAN1 interface.
• <1-4094> – Configures the native VLAN’s ID between 1 - 4094.
• aap-native-vlan-tag [<1-2>] [tagged|untagged] – Configures the native
VLAN’s tag.
• <1-2> – Specifies the LAN interface (1: LAN1, 2: LAN2).
• tagged – Specifies as tagged.
• untagged – Specifies as untagged.
• adoption-policy [allow|deny] – Specifies the adoption policy.
• allow – Allows adoption.
• deny – Denies adoption.
• country-code <WORD> – Configures the country of operation.
• <WORD> – Specify the 2 letter ISO-3166 country code
Note: Use the
show wireless country-code-list
command to
view a list of supported countries. On setting the country code, regulatory
configurations (for example, channels and self-healing offset) of configured
radios will be reset.
• lan-acl – Applies an ACL on LAN port for AP.
• location – Configures the AP’s location description.
• name – Configures the AP’s name description.
• radio-config – Sets radio configuration.
Comments to this Manuals