Advanced Features
English
28
When your radio receives an Emergency Alarm, it displays the
Emergency Alarm received indications for approximately, 10
seconds.
Receiving an Emergency Alarm with Call
Procedure:
1 When receiving an Emergency Alarm with Call, the first line
of the display shows the alias or ID of the sender. The
second line displays Alarm Rcvd.
2 A tone sounds and the red LED blinks.
3 Press R to clear the alarm indication.
OR
If no button is pressed, the alarm indication exits
automatically after a short duration.
4 You hear a voice from the Emergency Alarm with Call
initiating radio.
5 Press PTT button to initiate a call with the emergency
initiating radio. The green LED lights up.
6 Wait for the Talk Permit Tone to finish (if enabled) and
speak clearly into the microphone.
7 Release the PTT button to listen. When the emergency
initiating radio responds, the green LED blinks.
Sending an Emergency Call
This feature gives your radio priority access on a channel.
NOTE: The radio operates in the normal dispatch manner
while in Emergency Call, except, if enabled, it returns
to one of the following:
• Tactical/Non-Revert – You talk on the channel you
selected before you entered the emergency state.
• Non-Tactical/Revert – You talk on a programmed
emergency channel. The emergency alarm is sent
on this same channel.
Procedure:
1 Press the programmed Emergency button or the
Emergency footswitch.
2 The display shows Emergency on the second line. The
green LED lights up and the Emergency icon appears on the
Home screen display.
OR
The radio sounds a low-pitched tone, if the selected channel
does not support emergency. Select a channel that shows
Emergency.
3 Press and hold the PTT button. Speak clearly into the
microphone.
4 Release the PTT button to end the transmission and wait for
a response from the dispatcher.
NAG_LACR.book Page 28 Thursday, November 12, 2009 10:17 AM
Comments to this Manuals