Motorola MVME712A/D3 User Manual download pdf (Page 38)

Diagnostic Firmware

2-6 167Bug Debugging Package UserÕs Manual

Display Error Messages - Command DEM

This command allows you to display (dump) the internal error message buffer

of the diagnostic monitor manually.

Display Pass Count - Command DP

A count of the number of passes in Loop-Continue (LC) mode is kept by the

monitor. This count is displayed with other information at the conclusion of

each pass. To display this information without using LC, enter DP.

Help - Command HE

On-line documentation has been provided in the form of a Help command

(syntax: HE [command name]). This command displays a menu of the top level

directory of utility commands and test group names if no parameters are

entered, or the menu of a subdirectory if the name of that subdirectory is

entered. (The top level directory lists Ò(DIR)” after the name of each command

that has a subdirectory.) For example, to bring up a menu of all the memory

tests, enter HE RAM. When a menu is too long to fit on the screen, it pauses

until you press the carriage return, <CR>, again. To review a description of an

individual test, enter the full name, i.e., HE RAM CODE displays information

on the RAM Code Execution/Copy test routine. The Help screen is shown in

Figure 2-1. Help Screen on page 2-7.

Help Extended - Command HEX

The HEX command goes into an interactive, continuous mode of the HE

command. The syntax is HEX<CR>. The prompt displayed for HEX is the?.

You may then type the name of a directory, or command. You must type QUIT

to exit.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 238 239

No comments

Motorola MVME712A/D3 User Manual Page 38