Motorola M3097 Service Manual download pdf (Page 42)

Motorola Confidential Proprietary

31

Introduction

Manual Test Mode software allows service

personnel to monitor the telephone status on

the display, and manually control tele-phone

functions via the keypad.

Manual Test Mode operates at two levels: 1)

Status Display level, which allows the phone

to operate normally while providing status

indications in the display; and 2) Servicing

Level, which disables normal call-processing

and allows commands to be entered through

the keypad to manually control operation of

the phone.

Entering Manual Test Mode

Manual Test Mode is entered by entering the

following keypad sequence:

FCN 0 0 * * T E S T M O D E STO

Once this key sequence is completed the Sta-

tus Display screen appears. Press and hold

the # key for 2 seconds to enter in manual

test mode.

Figure 19: “Connections for PCS Testing” on

page 38 shows the recommended test setup.

Status Display Level

Status Display level is the power-up state in

manual test mode. In this level of manual

test mode the phone will place and receive

calls as normal, but the display shows two

lines of status information.

The display alternates between the channel

number, RSSI status information, and pri-

mary status information:

• SAT frequency

• Carrier state

• Signaling tone state

• Power level

• Voice/data channel mode

• Audio states

• DVCC and BER measurements

The format of this status information is

shown in Figure 17: “Test Mode Status Dis-

play (Analog Mode)” on page 35 and Figure

18: “Test Mode Status Display (Digital

Mode)” on page 36.

When dialing a phone number, the status

display ceases when the first digit of the

phone number is entered. The telephone

number is then displayed as it is entered.

When the Snd, End, or Clr button is pressed,

the status information display resumes. The

phone remains in Status Display Mode if the

# key is pressed momentarily.

Manual Test Mode

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 132 133

Comments to this Manuals

No comments