Motorola M3097 Service Manual Page 113

  • Download
  • Add to my manuals
  • Print
  • Page
    / 133
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 112
TDMA M3090/M3097: B+ Disconnect / Driver B+
Description
The overvoltage circuit consist of a voltage detector (U1100) and a power switch(Q1100). A resistor divider network at the input of U1100 is used to set the EXT_B+
detect voltage to 9.2V nominal. U1100 outputs low when ever the input voltage is below the detector threshold. During normal operating voltages from EXT_B+ the gate
voltage of Q1100 is zero, which turns Q1100 on. When Q1100 is on, SW_EXT_B+ is connected to EXT_B+. When EXT_B+ voltage is above 9.875V nominally, U1100
output becomes open drain. This causes the gate of Q1100 to be pulled up to the EXT_B+, which turns Q1100 off and thus disconnects the voltage to SW_EXT_B+.
Q1102-A and Q1102-B act as inverters. Therefore, a low state at the output of U1100 will result with a low state at the gate of Q1100 and vise versa.
The EXT_EN line disables the charging circuit when the phone is transmitting (as when making a call) and connected to a wall charger. It does this by cutting off the
SW_EXT_B+ line. This doe s not occur if the charg er is a CLA.
U1590 is a PA Pre-Driver Voltage Regulator that provides 3V to both 800MHz and 1900MHz RF pre-drivers.
U1100
Q1102-A
Q1102-B
EXT_B+
EXT_B+
Q1100
SW_EXT_B+
EXT_EN
Driver_B+
V_Buck
U1590
B30
Page view 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 132 133

Comments to this Manuals

No comments