Motorola 2247-N8 Specifications download pdf (Page 65)

set ip ethernet A ip_address

consists of two keywords (

, and

ethernet

) and one argument (

ip_address

). When you use the com-

mand to configure your Gateway, you would replace the argument with a value appropriate to your site.

For example:

set ip ethernet A 192.31.222.57

Guidelines: CONFIG Commands

The following table provides guidelines for entering and formatting CONFIG commands.

If a command is ambiguous or miskeyed, the CLI prompts you to enter additional information. For example, you

must specify which virtual circuit you are configuring when you are setting up a Motorola Netopia® Gateway.

Displaying Current Gateway Settings

You can use the

view

command to display the current CONFIG settings for your Motorola Netopia® Gateway. If

you enter the

view

command at the top level of the CONFIG hierarchy, the CLI displays the settings for all

enabled functions. If you enter the

view

command at an intermediate node, you see settings for that node and its

subnodes.

Step Mode: A CLI Configuration Technique

The Motorola Netopia® Gateway command line interface includes a step mode to automate the process of enter-

ing configuration settings. When you use the CONFIG step mode, the command line interface prompts you for all

required and optional information. You can then enter the configuration values appropriate for your site without

having to enter complete CLI commands.

When you are in step mode, the command line interface prompts you to enter required and optional settings. If a

setting has a default value or a current setting, the command line interface displays the default value for the com-

mand in parentheses. If a command has a limited number of acceptable values, those values are presented in

brackets, with each value separated by a vertical line. For example, the following CLI step command indicates that

the default value is

off and that valid entries are limited to on and off.

Command

component

Rules for entering CONFIG commands

Command verbs CONFIG commands must start with a command verb (set, view, delete).

You can truncate CONFIG verbs to three characters (set, vie, del).

CONFIG verbs are case-insensitive. You can enter “SET,” “Set,” or “set.”

Keywords Keywords are case-insensitive. You can enter “Ethernet,” “ETHERNET,” or “ethernet” as a

keyword without changing its meaning.

Keywords can be abbreviated to the length that they are differentiated from other key-

words.

Argument Text Text strings can be as many as 64 characters long, unless otherwise specified. In some

cases they may be as long as 255 bytes.

Special characters are represented using backslash notation.

Text strings may be enclosed in double (“) or single (‘) quote marks. If the text string

includes an embedded space, it must be enclosed in quotes.

Special characters are represented using backslash notation.

Numbers Enter numbers as integers, or in hexadecimal, where so noted.

IP addresses Enter IP addresses in dotted decimal notation (0 to 255).

1 ... 64 65 66 ... 108

Comments to this Manuals

No comments

Motorola 2247-N8 Specifications Page 65

Comments to this Manuals

Related products and manuals for Gateways/controllers Motorola 2247-N8