Motorola MOTO 9C START (WM6.1) Specifications download pdf (Page 156)

B - 2 MC9190-G Integrator Guide

General Recommendations

The MC9190-G should not be placed in a cradle or connected when the host computer to which it is physically

connected is started or restarted. If the MC9190-G is cradled when the host computer is started or restarted, the

MC9190-G attempts to connect before ActiveSync has fully loaded and a proper connection is impossible. Follow

these general guidelines for avoiding connection problems:

•

Connect only one MC9190-G to the host computer at a time. (More than one serial cable/cradle or USB

cable/cradle can be connected simultaneously.)

•

When starting or restarting the host computer, wait for the start process to finish completely before placing

the MC9190-G in a cradle. When cradled, it is able to make the connection defined in iDockIt settings.

•

If the MC9190-G was connected to the host computer when the host computer was started, remove the

MC9190-G from the cradle, restart the host computer, and then return the MC9190-G to the cradle.

•

Performing a warm boot on the MC9190-G can be useful. Remove the MC9190-G from the cradle before

performing a warm boot. Restart iDockIt and then recradle the MC9190-G.

•

For additional information, refer to Microsoft ActiveSync Help on your host computer.

Prepare the MC9190-G To Connect

When using Microsoft ActiveSync, first established a partnership between the MC9190-G and the host computer.

This should occur the first time the MC9190-G is placed in a cradle. If using an Ethernet cradle, first set up the

partnership with the host computer using a serial or USB cable or cradle.

Enable iDockIt To Manage Connections Automatically

To connect automatically to a host computer or network:

1. Check Enable iDockIt.

2. Check or uncheck Display status when cradled.

3. Check or uncheck Display settings when cradled.

4. Check or uncheck Autoconnect.

5. Tap the iDockIt tab (Ethernet, Direct or Modem) that corresponds to the cradle type.

6. Check Establish network connection and optionally Launch application.

Enable iDockIt To Manage Connections Manually

To connect manually to a host computer or network:

1. Check Enable iDockIt.

2. Check or uncheck Display status when cradled.

3. Check Display settings when cradled. When the MC9190-G is placed in the cradle, the Settings tab

displays automatically.

4. Uncheck Autoconnect.

5. Tap the iDockIt tab (Ethernet, Direct or Modem) that corresponds to the cradle type.

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 191 192

No comments

Motorola MOTO 9C START (WM6.1) Specifications Page 156