Motorola MTS HDTV set-top box Technical Information download pdf (Page 20)

MTS HDTV Service

Section 2 – Set Volume, Channel and Power Options

The defaults for your power, volume and channel control are that they always send the codes to the

Receiver not matter what mode you are in. Thus in DVD mode, the volume still controls the Receiver, etc.

If you would like to change this follow these instructions:

A. Volume Control Set Up Options

The volume commands are always sent to the Receiver until the TV mode key is programmed. Then the

volume commands are sent to the TV from all mode keys. If you’d like the volume commands to still be sent

to just one device, but that it be different device (for example a home theatre setup) then follow the

instructions in I. Volume Always Controls the Same Device

. If you’d like the volume command sent to

different devices depending on which mode you are in then go to II. Volume Control Depends on Device

Selected.

I. Volume Always Controls the Same Device

1. Press and hold the STB key on the remote control

2. Without releasing the STB key, press and hold the OK key simultaneously

3. Release both the STB key and the OK key – All the mode keys will flash twice indicating

programming mode

4. Enter 955 by pressing the number keys on the remote control – The STB key will flash twice

indicating correct entry

5. Press the mode key that you want to always receive the volume commands – The selected mode

key will flash three times indicating successful assignment and return to normal operation

The volume commands will now go to the selected device no matter what mode you are in.

II. Volume Control Depends on Device Selected

The volume setting can also be reconfigured to independently control the volume associate with each

device. (E.g. In AUX mode the receiver controls the audio; In TV mode the TV controls the audio)

1. Press and hold the STB key on the remote control

2. Without releasing the STB key, press and hold the OK key simultaneously

3. Release both the STB key and the OK key – All the mode keys will flash twice indicating

programming mode

4. Enter 955 by pressing the number keys on the remote control – The STB key will flash twice

indicating correct entry

5. Press the ENTER key – The STB key will flash tree times indicating successful assignment and

return to normal operations

B. Channel Selection Set Up Option

By default the remote control will always send channel commands to the Receiver no matter what mode you

are in. This will prevent accidental TV channel changes while in TV, DVD or AUX modes.

Channel selection can also be reconfigured to independently send channel commands to different devices

depending on what mode you are in (e.g., In STB mode the remote sends channel command to the

Receiver; In TV mode the remote sends channel commands to the television). To do this, follow these

instructions:

1. Press and hold the STB key on the remote control

1 ... 19 20 21 ... 65

No comments

Motorola MTS HDTV set-top box Technical Information Page 20