Motorola MTS HDTV set-top box Technical Information download pdf (Page 19)

MTS HDTV Service

Now that your devices are programmed, you can press the appropriate mode key on the remote control to

work with the selected device. To use the remote control for your Receiver again, press the STB mode key.

B. Using the Automatic Search

You can search the remote control memory for your 4 digit manufacture device code. Also use this function

if the code for your device is not listed in the Manufacturer Code List

1. Turn on the device you wish to program

2. Point the remote control at the device

3. Press and hold the mode key (i.e. TV, DVD or AUX) you want to program

4. Without releasing the selected mode key, press and hold the OK key simultaneously

5. Release both the mode key and the OK key – All mode keys will flash twice indicating

programming mode

6. Enter 922 by pressing the number keys on the remote control

a. The selected mode key will flash twice indicating correct entry (For AUX searching only,

press and release the PLAY key then press:

1 for VCR

2 for Receiver/Tuner

3 for Amplifier

4 for Home Theatre In the Box (HTIB)

The AUX mode keys will flash twice indicating correct entry

7. Press and hold PLAY key and wait until the device turns off, then release the PLAY key

a. The REW key can be unitized to go back through the codes one at a time

b. The FF key can be utilized to move forward through the codes one at a time

8. To save the code press the ENTER key on the remote control or press the EXIT key to return to

normal operations - The selected mode key will flash three times and return to normal operations

9. If no valid code is found, the green backlight will flash 2 times and the remote control will return to

normal operation.

10. Turn the device back on and use the remote to control you device. Now that your devices are

programmed you can press the appropriate mode key on the remote control to work with the

selected device. To use the remote control for your Receiver again, press the STB mode key.

a. You may need to repeat steps 1 through 8 to find a code

Note: If any other key is pressed except PLAY, ENTER, POWER, EXIT, REW, FF or number keys 1 to

4 the selected mode key will give a long red flash (error message) and the remote control will return to

normal operation and you will need to start over.

If you are interrupted while you are programming, the remote control may time-out before you complete

the code setup and you will need to start over. This is indicated by two quick flashes of the green

backlighting.

1 ... 18 19 20 ... 65

No comments

Motorola MTS HDTV set-top box Technical Information Page 19