Motorola PTP 500 User Manual download pdf (Page 16)

Cable Preparation and Installation

Step 4: When the gland body has been fitted, tighten the gland back shell.

Caution! Do not over tighten the gland back shell.

Gland on the right-hand side has been over tightened. As a result, the internal seal

and structure have been damaged:

Step 5: Should it be necessary to disconnect the cable at the ODU (or PTP LPU), this can

be achieved by removing the gland back shell first. Then, wiggle the cable to release the

tension of the gland body as shown in the figure below. Then you can unscrew the gland

body and depress the RJ45 locking tab with a small screwdriver.

Apply small movements to the cable until you see a gap here before

unscrewing the gland body.

More information:

PTP 300 Series User Guide

or PTP 500 Series User Guide

Section: “Connecting Up”

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

No comments

Motorola PTP 500 User Manual Page 16