Motorola PTP 500 User Manual download pdf (Page 7)

Bench Testing (Optional)

NOTE: If the power LED does not illuminate, remove the power cable and the ODU

connection from the PIDU Plus. Re-connect the power lead and check the power

LED illumination (green). If the power LED still does not light then check the power

source.

Step 6: Connect a second Ethernet cable (shown in yellow) to the “LAN” socket of the PIDU

Plus.

Step 7: 30 seconds after powering, the Ethernet LED should be observed to flash slowly 10

times. If the Ethernet LED does not illuminate (orange), then either the PIDU Plus or the

cable to the ODU may be faulty. Replace cable and/or PIDU Plus and repeat from Step 1.

Step 8: Ensure PC is set to correct IP address 169.254.1.x, where 2 < x < 254. Connect the

LAN cable to the PC (shown here in yellow).

NOTE: If this IP address is not recognised, try 10.10.10.11 (Master) and 10.10.10.10

(Slave). Some units may have been pre-configured with these IP addresses. If it is

necessary to use IP addresses 10.10.10.11 and 10.10.10.10, ensure that the PC is

configured with an IP address of 10.10.10.n, where n is any value between 2 and

254 but excluding 10 and 11, to configure these units.

Step 9: Check that the Ethernet LED is now ON. If the LED does not show any activity

when accessing web pages, refer to “Testing and Fault Finding (Troubleshooting)”.

CAUTION: Do not dress the RJ45 cables too tightly, as this may make the connections

unreliable.

More information:

PTP 300 Series User Guide

or PTP 500 Series User Guide

Section: “Connecting Up”

1 2 3 4 5 6 7 8 ... 26

No comments

Motorola PTP 500 User Manual Page 7