Motorola MSC8101 ADS User Manual download pdf (Page 21)

MOTOROLA MSC8101ADS RevB User’s Manual 21

Installation Instructions

FIGURE 3-3 Stand Alone Configuration

3•4 +5V Power Supply Connection

The MSC8101 requires +5V DC @ 4A max, power supply for operation. Connect the +5V power

supply to connector P26 as shown below:

FIGURE 3-4 P26: +5V Power Connector

P26 is a 3 terminal block power connector with power plug. The plug is designed to accept 14 to

22 AWG wires. It is recommended to use 14 to 18 AWG wires. To provide solid ground, two GND

terminals are supplied. It is recommended to connect both GND wires to the common of the power

supply, while “Hot” line is connected with a single wire.

NOTE

Since hardware applications may be connected

to the MSC8101ADS via the expansion connec-

tors P1 and P2, the additional power consump-

tion should be taken into consideration when a

power supply is connected to the MSC8101ADS.

3•5 JTAG/OnCE Connector - P6

The MSC8101ADS JTAG/OnCE connector, P6, is a 14 pin, two rows, header connector with key.

The connection between the MSC8101ADS and the Command Converter is by a 14 line flat cable,

Host

Computer

5V Power Supply

(

T1/E1

four ch.

Audio

Stereo

+5V

GND

Frees

cale Semiconductor,

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

nc...

1 ... 20 21 22 ... 119

No comments

Motorola MSC8101 ADS User Manual Page 21