Motorola VT1005 - Vonage VOIP Broadband Gateway Modem Installation Guide download pdf (Page 9)

VOICENT COMMUNICATIONS INC

- 9 -

If in step 5 the driver provider is Microsoft, then your driver installation

is not correct. The default Microsoft driver does not support voice. Please

click Update Driver button to install the correct modem driver.

If your modem is installed successfully, then simply connect your

telephone wall jack to the modem jack marked LINE. You can also

connect a regular phone to the other modem jack marked PHONE.

As mentioned in system requirement, there are two ways to setup a

phone line for Voicent software to work. One is to use normal telephone

line; the other is to use Voice over IP connection.

A). Regular telephone line

When you use a regular phone line, please make sure to plug one end of

the phone connector into the modem jack marked LINE. Plug the other

end into a phone jack (the wall jack where you normally connect a

phone). If you have a spare phone available, plug your phone into the

modem PHONE jack if you want to use a phone on the same line with the

modem. Your phone will work normally even if the computer is turned off.

You can use the phone to test the phone line.

B). Voice over IP

When you use Voice over IP (VOIP), a voice terminal (adaptor) is required

and is usually provided by your service provider. For example, Vonage

uses Motorola VT1005 Voice Terminal. Your modem should be connected

to the line jack of the voice terminal.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

No comments

Motorola VT1005 - Vonage VOIP Broadband Gateway Modem Installation Guide Page 9