Motorola LM100 Operations Instructions download pdf (Page 39)

4-4 Operation

GX2-LM1000E* Installation and Operation Manual

 If the RF drive level to the laser is OFF when you turn the optical output power OFF, it will

remain off when the optical output power is restored.

Quick Swap

The quick-swap feature reduces down time by eliminating the need to manually reconfigure

replacement application modules of the same type in the same housing slot. Replacement

modules are recognized and updated with settings pre-stored by the GX2-CM100B control

module. This feature is particularly useful in the event of module failure.

The following module-specific parameters are contained in the quick-swap message sent from

the GX2-CM100B to the GX2-LM1000E*:

 Module Alias

 RF input on/off control setting

 Optical output on/off control setting

 Primary operating mode

 Secondary operating mode

 CW/Video mode offset

 Laser RF input level control (OMI offset)

 RF attenuator setting

The GX2-LM1000E* reads the quick-swap message from the GX2-CM100B, automatically

resets, and re-initializes itself to the same configuration as contained in the message. If the

GX2-LM1000E* is in Preset mode, it uses the factory default optimum OMI setting to determine

the RF level at the laser. If the GX2-LM1000E* is in Set mode, the laser RF input level control

(OMI offset) determines the RF level at the laser. If the GX2-LM1000E* is in Manual mode, the

attenuator setting determines the RF level at the laser. If the quick-swap message intended for

the GX2-LM1000E* is sent to another type of module, the command is rejected and the module

information is not replaced.

Instructions for selecting and implementing the quick-swap mode are provided in the

GX2-CM100B Control Module Installation and Operation Manual.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 60 61

No comments

Motorola LM100 Operations Instructions Page 39