Motorola AP6562 Installation Guide download pdf (Page 26)

26 AP6562 Access Point

• Standalone AP - Select this option to deploy this Access Point as an autonomous fat Access Point.

A Standalone AP isn't managed by a Virtual Controller AP, or adopted by a controller

11. Select the Country Code of the country where the Access Point is deployed. Selecting a proper country

is a critical task while configuring the Access Point, as it defines the correct channels of operation and

ensures compliance to the regulations of the selected country. This field is only available for the Typical

Setup Wizard.

12. Select Next to set the Access Point’s network mode.

NOTE If wanting to adopt the Access Point to a controller or service platform,

use the controller or service platform’s resident UI to connect to the

Access Point, provision its configuration and administrate the Access

Point’s configuration.

NOTE If designating the Access Point as a Standalone AP, Motorola Solutions

recommends the Access Point’s UI be used exclusively to define its

device configuration, and not the CLI. The CLI provides the ability to

define more than one profile and the UI does not. Consequently, the two

interfaces cannot be used collectively to manage profiles without an

administrator encountering problems.

1 ... 25 26 27 ... 48

No comments

Motorola AP6562 Installation Guide Page 26