Motorola AP6562 Installation Guide download pdf (Page 12)

12 AP6562 Access Point

2.3.4 Vertical Pole Mount

Use the following procedures for vertical pole mount installations. The extension arm is recommended when

mounting the access point to poles greater than 3 inches is diameter.

For poles up to 3 inches in diameter when using a U-bolt

1. Thread the two inner nuts onto the U-bolt. Place the U-bolt at the desired mounting location.

2. Place the pole mount bracket section on the U bolt. Adjust the inner nuts until the pole mount bracket

section is against the pole and the U-bolt can be secured tightly to the pole.

3. Place the angle adapter bracket section on the U-bolt with the open slot connections on the bottom and

align it with the pole mount section.

4. Put the two outer nuts on the U-bolt to attach the angle adapter bracket section to the pole mount bracket

section.

5. Tighten all nuts to 300 inch pounds (lbf-in).

6. Position the access point bracket section so that the bottom of the section with the straight (not bevel cut)

side is oriented toward the bottom side of the access point. Using a torque wrench or a ratchet and a

10mm socket, or an adjustable wrench, attach (but don’t tighten) the access point bracket section to the

AP6562 with the with four M6 hex flange screws.

7. Insert two M6 hex flange screws into the bottom holes on the sides of the access point bracket section.

8. Insert the two M6 hex flange screws in the bottom holes on the sides of the access point bracket section

into the open slot connections on the bottom of the angle adapter bracket section.

9. Rotate the access point bracket section upward and align the top holes on the sides with the top holes on

the angle adapter bracket section. Insert two M6 hex flange screws into the top holes on the angle

adapter bracket section.

10. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, to finish attaching the

access point bracket section to the angle adapter bracket section with the M6 hex flange screws in the

open slot connections and the top holes on the angle adapter bracket section. Do not tighten the screws

until all rotation and tilt adjustments are complete.

11. To adjust the position of the access point, rotate the access point bracket section (plus or minus 15

degrees) and tilt the angle adapter bracket section (up to 45 degrees).

12. Tighten all hex flange screws to 60 inch pounds (lbf-in).

13. If required, install and attach a Kensington security cable (customer supplied) to the unit’s lock port.

14. Attach an Ethernet cable from the access point to a controller with an 802.3at-compatible power source

or use the designated outdoor rated power supply (AP-PSBIAS-7161-US or AP-PSBIAS-7161-WW) to

supply power to the AP6562 (once fully cabled).

NOTE The extension arm is recommended for installations on poles greater than 3 inches in

diameter.

1 ... 11 12 13 ... 48

No comments

Motorola AP6562 Installation Guide Page 12