Motorola MC9090-G User's Guide download pdf (Page 45)

Operating the MC9090-G RFID 2 - 17

Reading RFID Tags

When in the RFID read mode, pull the trigger and the mobile computer interrogates the tags. The mobile computer

captures data from each new tag found. When the trigger is released, the mobile computer stops interrogating

tags. In addition, RFID tag data can be stored on the mobile computer.

For more information about reading RFID tags, using MC9000-G RFID mobile computers and using the MC9090-G

RFID sample application, see the MC9090-G RFID Integrator Guide Supplement, p/n 72E-79963-xx.

To Read RFID Tags:

1. The mobile computer must have an RFID tag reading application installed and running.

2. Aim the mobile computer at the tag and orient the mobile computer horizontally or vertically (depending on the

tag orientation, see Figure 2-20).

Figure 2-20

RFID Tag Read

3. Pull the trigger, an audible beep sounds and the Indicator LED bar flashes green one time to indicate the tag

was read.

4. Release the trigger.

NOTE Typical tag range is 0.2 ft. - 10 ft. (0.061 m to 3.1 m), moving the reader motion horizontally and/or

vertically may enhance tag reading.

The mobile computer can be configured so that any button (including or excluding the trigger) can be

used to initiate a tag read. The successful read indications (beep, LEDs etc.) can also be selected by the

application.

The mobile computer continues to read tags as long as the trigger remains pulled.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 77 78

No comments

Motorola MC9090-G User's Guide Page 45