Motorola III User Manual download pdf (Page 13)

12 Getting Started (cont.)

Alert Tone Indications

The MTS 2000 radio generates a number of audible tones to indicate radio

operating conditions:

•

Low Battery – A low-battery condition is indicated by a high-pitched, cricket-like

“chirp-chirp” when the PTT switch is released following a transmission.

•

Successful Power-Up – A short, medium-pitched tone when the radio is first

turned on indicates that the radio has passed its power-up self test and is

ready for use.

•

Unsuccessful Power-Up – A short, low-pitched tone when the radio is first

turned on indicates that the radio has failed its power-up self test and is not

ready for use. Contact your service representative for service.

•

Transmit on Receive-Only Mode – If you press the PTT switch while tuned to a

“receive-only” mode, you will hear a continuous, low-pitched alert tone,

indicating that no transmission is possible on this mode. This tone will continue

until the PTT switch is released.

•

Transmit Inhibit on Busy Mode – If you press the PTT switch while the mode is

busy, you will hear a continuous, low-pitched alert tone, indicating that no

transmission is possible on this mode. This tone will continue until the PTT

switch is released.

•

Invalid Mode – A continuous, low-pitched tone is heard when an invalid or

unprogrammed operation is attempted on the radio.

•

Valid (Good) Key Press – A short, medium-pitched tone when a keypad key is

pressed indicates that the key press was accepted.

•

Invalid (Bad) Key Press – A short, low-pitched tone when a keypad key is

pressed indicates that the key press was rejected.

•

Emergency Alarm Entry – A short, medium-pitched tone when the emergency

button is pressed indicates that the radio has entered the emergency mode.

•

Emergency Alarm/Call Exit – A continuous, medium-pitched tone when the

radio is in the emergency mode indicates that the radio has exited the

emergency mode.

•

Failsoft (Trunked Systems Only) – A faint “beeping” tone every ten seconds

indicates that the radio is operating in the failsoft mode.

•

Time-Out Timer Warning – Your radio’s time-out timer limits the length of your

transmission time. When you are pressing the PTT switch (transmitting), a

short, low-pitched warning tone will sound four seconds before the allotted

time will expire.

•

Time-Out Timer Timed-Out – If you hold down the PTT switch longer than the

time-out timer’s allotted time, a continuous, low-pitched tone will sound,

indicating that your transmission has been cut off. This tone will continue until

the PTT switch is released.

•

Phone Busy – A “bah-bah-bah-bah” tone when telephone interconnect is

accessed indicates that all available modes are busy and the radio is in queue

for the next available phone line.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 126 127

Comments to this Manuals

No comments

Motorola III User Manual Page 13

Comments to this Manuals