Motorola CPU32 User's Guide download pdf (Page 42)

CPU32 Emulation 41

Chapter 2: Connecting the Emulation Probe to a LAN

Connecting the Emulation Probe to a LAN

To verify LAN communications

1 Verify your emulation probe is now active and on the network by

issuing a telnet to the IP address.

This connection will give you access to the emulation probe’s built-in

terminal interface.

2 To view the LAN parameters, enter the lan command at the

terminal interface prompt.

3 To exit from this telnet session, type <CTRL>D at the prompt.

The best way to change the emulation probe’s IP address, once it has

already been set, is to telnet to the emulation probe and use the

terminal interface lan command to make the change. Remember, after

making your changes, you must cycle power or enter a terminal

interface init -p command before the changes take effect. Doing this

will break the connection and end the telnet session.

If You Have Problems

“Troubleshooting the Emulator” on page 159.

Example

$ telnet 192.35.12.6

R>lan

lan is enabled

lan -i 192.35.12.6

lan -g 0.0.0.0

lan -p 6470

Ethernet Address : 08000F090B30

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 204 205

No comments

Motorola CPU32 User's Guide Page 42