1-14 M5282EVB User’s Manual
PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE
Communication Ports
1.4.3 10/100T Ethernet Port
The MCF5272 device performs the full set of IEEE 802.3/Ethernet CSMA/CD media access
control and channel interface functions. The MCF5282 Ethernet Controller requires an external
interface adaptor and transceiver function to complete the interface to the ethernet media. The
MCF5282 Ethernet module also features an integrated fast (100baseT) Ethernet media access
controller (MAC).
The Fast Ethernet controller (FEC) incorporates the following features:
• Full compliance with the IEEE 802.3 standard
• Support for three different physical interfaces:
— 100 Mbps 802.3 media independent interface (MII)
— 10 Mbps 802.3 MII
— 10 Mbps seven-wire interface
• Half-duplex 100 Mbps operation at system clock frequency 50 MHz
• 448 bytes total on-chip transmit and receive FIFO memory to support a range of bus
latencies. Note: the total FIFO size is 448 bytes. It is not intended to hold entire frames but
only to compensate for external bus latency. The FIFO can be partitioned on any 32-bit
boundary between receive and transmit, for example, 32 x 56 receive and 32 x 56 transmit.
• Retransmission from transmit FIFO following a collision, no processor bus used
• Automatic internal flushing of the receive FIFO for runts and collisions with no processor
bus use
For more details see the MCF5282 Users manual, this module’s signals are also brought to
expansion connector J3. The on board ROM MONITOR is programmed to allow a user to
download files from a network to memory in different formats. The current compiler formats
supported are S-Record, COFF, ELF or Image.
1.4.4 BDM/JTAG Port
The MCF5282 processor has a Background Debug Mode (BDM) port, which supports Real-Time
Trace Support and Real-Time Debug. The signals which are necessary for debug are available at
connector (J4). Figure 1-3., “J4- BDM Connector pin assignment” shows the (J4) Connector pin
assignment.
Table 1-15. Ethernet Hardware Configuration
Jumper
Function (See AMD-AM79C874VC users manual for
function description)
JP8 Auto Negotiate
JP9 Tech 0
JP10 Tech 1
JP11 Tech 2
Comments to this Manuals