Motorola DIGITAL DS6708 User Manual Page 27
- Page / 458
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Getting Started 1 - 7
Wall Mount
To use the optional wall mount to mount the digital scanner on a wall, place the mount in the desired location on the
wall and secure by inserting two screws* appropriate for the mounting surface through the screw holes on the
mount, and into the surface. Insert the digital scanner into the mount as shown.
Figure 1-8
Securing the Wall Mount
*The recommended screws are two #6 screws (1” long) and two #6 washers.
For convenience, print this page and use the template below for mounting hole locations.
Figure 1-9
Wall Mounting Template
2.98”
Insert mounting
screw
Insert mounting
screw
- Symbol DS6708 Digital Scanner 1
- Product Reference Guide 3
- Warranty 4
- Revision History 5
- Table of Contents 7
- Table of Contents vii 9
- Table of Contents ix 11
- Table of Contents xi 13
- Table of Contents xiii 15
- About This Guide 17
- Notational Conventions 18
- Related Documents 19
- Service Information 19
- Chapter 1 Getting Started 21
- Supported Interfaces 22
- Unpacking 22
- Standard Model 23
- Model with Base 25
- Mounting the Digital Scanner 26
- Wall Mount 27
- Chapter 2 Scanning 29
- Beeper Definitions 30
- Scanning 2 - 3 31
- LED Definitions 32
- Scanning in Hand-Held Mode 32
- Scanning 2 - 5 33
- Scanning in Presentation Mode 34
- Scanning 2 - 7 35
- Decode Zones 36
- Scanning 2 - 9 37
- Specifications 39
- Troubleshooting 40
- Table 3-1 41
- Technical Specifications 43
- Table 3-2 44
- Digital Scanner Options 47
- Scanning Sequence Examples 48
- Table 4-1 49
- *Enable Parameter Scanning 51
- *Medium Frequency 52
- *High Volume 53
- *Continuous On 53
- *1 Minute 54
- *Auto Aim 55
- *Disabled Always 56
- Presentation Mode 57
- Parameter # F1h, 74h 57
- Presentation Mode (continued) 58
- Decode Session Timeout 59
- Parameter # 88h 59
- Parameter # 89h 59
- *Beep After Good Decode 60
- Parameter # F1h 19h 61
- Transmit Code ID Character 62
- Parameter # 2Dh 62
- Prefix/Suffix Values 63
- *Data As Is 64
- FN1 Substitution Values 65
- Key Category Parameter # 67h 65
- Decimal Value Parameter # 6Dh 65
- *Disable No Read 66
- Synapse Interface 67
- Parameter # F0h, ACh 67
- Decoding Preferences 71
- *Full Illumination 72
- *Enable Decode Aiming Pattern 73
- Parameter # F1h, 61h 74
- Chapter 6 USB Interface 75
- Connecting a USB Interface 76
- USB Parameter Defaults 77
- Table 6-1 78
- USB Host Parameters 79
- Emulation device 80
- USB Interface 6 - 7 81
- *Disable Keypad Emulation 83
- *Disable Function Key Mapping 85
- *Disable Simulated Caps Lock 85
- *No Case Conversion 86
- ASCII Character Set for USB 87
- Table 6-2 88
- USB Interface 6 - 15 89
- USB Interface 6 - 17 91
- Table 6-3 92
- USB Interface 6 - 19 93
- Table 6-4 94
- USB Interface 6 - 21 95
- Table 6-6 96
- USB Interface 6 - 23 97
- Chapter 7 RS-232 Interface 99
- RS-232 Direct Connection 100
- RS-232 Interface 7 - 3 101
- RS-232 Parameter Defaults 102
- RS-232 Host Parameters 103
- Table 7-3 104
- RS-232 Host Types 105
- Baud Rate 106
- *Baud Rate 9600 107
- *1 Stop Bit 109
- *Check For Received Errors 110
- RS-232 Interface 7 - 13 111
- Software Handshaking 112
- RS-232 Interface 7 - 15 113
- *Minimum: 2 Sec 114
- *Host: Low RTS 115
- *Minimum: 0 msec 116
- *Normal Operation 117
- *Send Bar Code 117
- Table 7-4 118
- RS-232 Interface 7 - 21 119
- RS-232 Interface 7 - 23 121
- Introduction 123
- IBM Parameter Defaults 125
- IBM 468X/469X Host Parameters 126
- Convert Unknown to Code 39 127
- Table 9-1 132
- Wand Emulation Host Types 133
- *80 msec 134
- *Bar High/Margin Low 135
- Table 10-1 142
- Keyboard Wedge Host Types 143
- *North American 144
- Italian Windows 145
- Swedish Windows 145
- UK English Windows 145
- Japanese Windows 145
- Portuguese-Brazilian Windows 145
- *No Delay 146
- *Disable 147
- *Disable Caps Lock On 148
- *Disable Caps Lock Override 148
- *No Convert 149
- Keyboard Maps 151
- NCR 7052 58-Key 152
- Table 10-2 153
- Table 10-3 157
- Table 10-4 158
- Table 10-5 160
- Table 10-6 160
- Table 10-7 161
- Emulation host interface 165
- Table 11-1 166
- Scanner Emulation Host 167
- Parameter Pass-Through 168
- Convert Newer Code Types 169
- Module Width 169
- Code 39 Full ASCII Conversion 170
- Transmission Timeout 171
- Ignore Unknown Characters 172
- Leading Margin 172
- Leading Margin (continued) 173
- Check For Decode LED 173
- Chapter 12 123Scan 175
- Chapter 13 Symbologies 177
- Errors While Scanning 178
- Symbology Parameter Defaults 178
- Symbologies 13 - 3 179
- Table 13-1 180
- Symbologies 13 - 5 181
- *Enable UPC-A 183
- *Enable UPC-E 183
- *Disable UPC-E1 184
- *Enable EAN-8/JAN-8 184
- *Enable EAN-13/JAN-13 185
- *Disable Bookland EAN 185
- Parameter # 10h 186
- *Ignore Supplementals 187
- Parameter # 50h 189
- *Transmit UPC-A Check Digit 190
- *Transmit UPC-E Check Digit 190
- *Transmit UPC-E1 Check Digit 191
- UPC-A Preamble 192
- Parameter # 22h 192
- UPC-E Preamble 193
- Parameter # 23h 193
- UPC-E1 Preamble 194
- Parameter # 24h 194
- Convert UPC-E to UPC-A 195
- Parameter # 25h 195
- Convert UPC-E1 to UPC-A 195
- Parameter # 26h 195
- *Disable EAN/JAN Zero Extend 196
- Bookland ISBN Format 197
- Parameter # F1h 40h 197
- *Disable ISSN EAN 198
- Code 128 199
- *Code 128 - Any Length 200
- *Enable GS1-128 201
- *Enable ISBT 128 201
- *Disable ISBT Concatenation 202
- *Enable Check ISBT Table 203
- *Enable Code 39 204
- *Disable Trioptic Code 39 204
- *Disable Code 32 Prefix 205
- Set Lengths for Code 39 206
- Symbologies 13 - 31 207
- *Disable Code 39 Check Digit 208
- *Disable Code 39 Full ASCII 209
- Buffer Data 210
- Clear Transmission Buffer 210
- Symbologies 13 - 35 211
- *Disable Code 93 212
- Symbologies 13 - 37 213
- *Disable Code 11 214
- Symbologies 13 - 39 215
- Interleaved 2 of 5 (ITF) 217
- Symbologies 13 - 43 219
- Discrete 2 of 5 (DTF) 221
- Symbologies 13 - 47 223
- Codabar (NW - 7) 224
- Symbologies 13 - 49 225
- *Disable CLSI Editing 226
- *Disable NOTIS Editing 226
- *Disable MSI 227
- *One MSI Check Digit 229
- Chinese 2 of 5 230
- Matrix 2 of 5 231
- Set Lengths for Matrix 2 of 5 232
- Matrix 2 of 5 Redundancy 233
- Parameter # F1h 6Dh 233
- Matrix 2 of 5 Check Digit 233
- Parameter # F1h 6Eh 233
- Parameter # F1h 6Fh 234
- Inverse 1D 235
- Postal Codes 236
- *Enable UK Postal 237
- *Transmit UK Postal 238
- *Enable Japan Postal 238
- *Enable Australian Postal 239
- *Enable Netherlands KIX Code 239
- *Disable UPU FICS Postal 240
- *Enable GS1 DataBar-14 241
- *Enable GS1 DataBar Limited 241
- *Enable GS1 DataBar Expanded 242
- Composite 243
- *Disable TLC39 244
- *UPC Always Linked 244
- Composite Beep Mode 245
- Parameter # F0h, 8Eh 245
- Parameter # F0h, ABh 245
- 2D Symbologies 246
- *Disable Code 128 Emulation 247
- *Enable Data Matrix 248
- *Enable Maxicode 249
- *Enable QR Code 250
- *Enable MicroQR 251
- *Enable Aztec 251
- Aztec Inverse 252
- Parameter # F1h 4Dh 252
- Redundancy Level 253
- *Redundancy Level 1 254
- Security Level 255
- Report Version 256
- Macro PDF Features 257
- (DS6708-DL) 259
- Driver’s License Parsing 260
- Issue Date 263
- ID Number (Formatted) 263
- AAMVA Parse Field Bar Codes 264
- Parser Version ID Bar Codes 273
- Birth Date 277
- Field Update Procedure 278
- User Preferences 279
- Keyboard Characters 284
- Using ADF Bar Codes 300
- ADF Bar Code Menu Example 300
- Rule 2: The UPC Scanning Rule 301
- Alternate Rule Sets 301
- ADF Bar Codes 303
- Table 15-1 304
- Special Commands 305
- Save Rule 306
- Quit Entering Rules 306
- Disable Rule Set 307
- Criteria 308
- Code Types (continued) 309
- Code Lengths 315
- Code Lengths (continued) 316
- Specific String Search 320
- Any Message OK 320
- Numeric Keypad 321
- Numeric Keypad (continued) 322
- Rule Belongs To Set 323
- Send Data 324
- Send Data (continued) 325
- Setup Field(s) 328
- Move Cursor 329
- Setup Field(s) (continued) 330
- Skip Ahead 331
- Skip Back 332
- Skip Ahead (continued) 332
- Skip Back (continued) 333
- Send Preset Value 334
- Modify Data 335
- Pad Data with Spaces 336
- Pad Data with Zeros 340
- Control Characters 345
- Send ALT Characters 364
- Send Alt \ 368
- Send Alt ] 368
- Send Keypad Characters 369
- Send Function Key 374
- Send Function Key (continued) 375
- Send Right Control Key 381
- Turn On/Off Rule Sets 387
- Turn Off Rule Set 1 388
- Turn Off Rule Set 2 388
- Turn Off Rule Set 3 388
- Turn Off Rule Set 4 388
- Alphanumeric Keyboard 389
- Table A-1 403
- Symbol Code Identifiers 413
- Table B-1 414
- AIM Code Identifiers 415
- ]C1AIMID 416
- Programming Reference B - 5 417
- Table B-3 418
- Programming Reference B - 7 419
- Appendix C Sample Bar Codes 421
- Interleaved 2 of 5 422
- GS1 DataBar-14 423
- Data Matrix 423
- Maxicode 424
- US Postnet 424
- UK Postal 424
- Appendix D Numeric Bar Codes 425
- Numeric Bar Codes (continued) 426
- Table E-1 427
- ASCII Character Sets E - 3 429
- ASCII Character Sets E - 5 431
- Table E-2 432
- ASCII Character Sets E - 7 433
- Table E-3 434
- ASCII Character Sets E - 9 435
- Table E-5 436
- ASCII Character Sets E - 11 437
- Table E-7 438
- Glossary 439
- Glossary - 3 441
- Glossary - 5 443
- Glossary - 7 445
- Glossary - 9 447
- Numerics 449
- Index - 3 451
- Index - 5 453
- Tell Us What You Think 455
Related products and manuals for Scanners Motorola DIGITAL DS6708
Scanners Motorola LS7708 User Manual
(36 pages)
(36 pages)
Scanners Motorola LS3478 User Manual
(336 pages)
(336 pages)
Scanners Motorola BC796D User Manual
(84 pages)
(84 pages)
Scanners Motorola DS3478 User Manual
(404 pages)
(404 pages)
Scanners Motorola MC1000 User Manual
(70 pages)
(70 pages)
© 2020, manymanuals.com. All rights reserved. | 0.029 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals