Motorola MOSCAD 68P02958C00-B User Manual Page 234

  • Download
  • Add to my manuals
  • Print
  • Page
    / 474
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 233
SW Diagnostics & Loggers
5-177
Abort
The Abort command terminates retrieval of error logger or diagnostics information from the IP
Gateway.
View Menu
The following views are available to the user. Click on an entry to select it, and a check mark
will appear on the menu. The associated view will be displayed on the SW Diagnostics &
Loggers window. Those views which are specific to a given logger, are marked accordingly
below. Note that during execution, the icons displayed in the toolbars relate to the active tool.
Toolbar
The Toolbar displays the icons described under.
Status bar
The Status bar displays the status messages at the bottom edge of the SW Diagnostics &
Loggers window. This message area is read-only.
Site bar
The Site bar dialog enables the user to specify the location of the IP Gateway with which the
current logger tool communicates. The logger tool runs can be connected locally to an IP
Gateway or over a network to a remote IP Gateway in order to retrieve error or diagnostics
information. If you are connected locally to the IP Gateway, make sure that Local is selected.
If you are connected remotely, unselect Local and specify the Site ID and Link ID.
By default, the Site bar is displayed at the top of the SW Diagnostics & Loggers window. To
remove the bar, unselect it in the View menu.
Dialog box parameters
Local
When this box is checked, the logging is done for the locally connected IP Gateway. The
default setting for communication is Local.
Link ID
When the Local box is not checked, the logging is done for a remote IP Gateway connected to
the PC via the specified Link ID.
Site ID
When the Local box is not checked, the logging is done for the remote IP Gateway at the
specified Site ID connected to the PC via the above Link ID.
Loggers Bar
The Loggers Bar enables the user to launch a new logger tool and set it as the active tool.
Page view 233
1 ... 233 234 235 ... 474

Comments to this Manuals

No comments