Motorola DCT6208 Installation Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 89
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
3-10 Installation
DCT6200\DCT6208 Installation Manual
Connecting the IR Blaster
To connect the IR Blaster:
1 Fit the transmitter into the mounting bracket (refer to Figure 3-6).
2 Plug the mini-pin connector into the IR jack on the rear panel of the DCT* rear panel as
illustrated in Figure 3-7:
Figure 3-7
IR Blaster installed
A
UDIO OUT
AUDIO IN
TV
Pass Card
VIDEO
R
IN
L
OUT
S-VIDEO
IEEE 1394
OPTICAL
SPDIF
SPDIF
Y
Pb
Pr
ETHERNET
USB
IR
DVI-D OUT
TO
TV/VCR
CABLE
IN
DCT6200/DCT6208
VCR
Refer to text to locate
IR receiver on VCR
3 Remove the adhesive tape cover from the mounting bracket.
4 Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
careful to route the wire so that it does not prevent loading tapes.
Checking the IR Blaster
The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT*. As a final check, operate the VCR using the remote control from various positions in the
room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 88 89

Comments to this Manuals

No comments