Motorola M12 Oncore User's Guide download pdf (Page 162)

Chapter 5 - I/O Commands

VEHICLE ID (@@Gk)

Applicability: M12+ positioning and timing receivers

This message sets or defaults the ID tag. By default, the ID Tag is the 6 character serial number

of the receiver. The user may change the ID tag to any combination of six ASCII characters

between 0x20 (space) to 0x7E (tilde) that may aid in identification of a number of remote sites or

vehicles.Note that space characters (0x20) may only be used as fillers at the end of the ID tag.

Any out of range character will also cause the ID tag to remain unchanged. An ID tag modified by

the user will only be remembered through power cycles if battery back-up is provided.

The ID tag is also output in the 12-channel Position/Status/Data Message (@@Ha) status

message.

Default value: Receiver Serial Number

Legacy Code Compatibility: The @@Gk command was implemented in a similar fashion on the

Motorola M12 Oncore receivers.

Motorola GPS Products - M12+ User's Guide Revision 6.X 09FEB05

154

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 221 222

No comments

Motorola M12 Oncore User's Guide Page 162