Motorola DCP 501 User Manual download pdf (Page 91)

Operation 81

DCP501 User Guide

Selecting Preset Radio Stations

To select preset radio stations with the DCP501:

1 Press SOURCE to tuner or press AM/FM. DCP501 display shows:

 the last radio station tuned

 the band (AM or FM)

 the preset number assigned to that station (if any)

2 Press CHANNEL/PRESETST on the front of the DCP501, or channel up/down on the remote

control to retrieve the desired preset number or directly enter the preset number using the

numeric buttons on your DCP501 remote control. Each preset station number is displayed

with its radio band and frequency.

Sound Effects

The DCP501 has many sound effects that can be selected and stored. When the SOURCE is CATV,

cable TV providers may be using analog or Dolby Digital audio. The DCP501 allows you to select

and store a favorite sound effect for each. On any other

SOURCE, the DCP501 stores one analog

sound effect for each

SOURCE and one Dolby Digital sound effect that is used on all non-CATV

SOURCES

. Stored sound effects will be automatically selected by the DCP501 when returning to

that

SOURCE. Some sound effects can only be used on analog (or PCM) audio, and some only on

Dolby Digital audio. The dts sound effect can only be used on dts audio. The following sound

effects can be used on analog (or PCM) audio.

 Dolby Pro Logic II (movie, music)

 Dolby Pro Logic

 Dolby 3-Stereo

 Stereo

 Six DSP sound effects (Stadium, Concert, Theater, Arena, Club, Church)

The following sound effects can be used on Dolby Digital audio:

 Dolby Digital

 Dolby D+3Stereo

 Dolby D+Stereo

 Dolby D+PL II (movie, music, & emulation)

Dolby Pro Logic II (Dolby D+PL II) is a special case. Dolby D+PL II can only be used on

Dolby Digital audio if the signal is a Dolby Digital 2.0 signal. Sound effects selected on a

Dolby Digital 2.0 signal are stored separately from other selected Dolby Digital audio sound

effects, and will be automatically selected by the DCP501 when returning to that signal.

To operate the DCP501 audio mode:

1 Press audio MODE and the currently selected surround sound mode is displayed on the TV

and the DCP501 display.

2 Press audio MODE repeatedly to cycle through all available surround sound and DSP modes.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 140 141

No comments

Motorola DCP 501 User Manual Page 91