Motorola DCP 501 User Manual download pdf (Page 31)

Overview 21

DCP501 User Guide

Finding a Setup Code

Setup codes for your TV and VCR are listed by brand in “TV and VCR Setup Codes”.

If the setup code for your brand of TV or VCR is not listed, or if your TV or VCR does not

respond to the setup codes listed for its brand, you can search for your setup code using your

remote control’s Step and Set function.

To search for a setup code:

1 Press the mode button for the device (either TV, VCR 1 or VCR 2) for six seconds.

The mode buttons will turn on and turn off one at a time. This sequence will repeat two

times and then the selected mode button will remain on. This indicates the remote is ready

to use the Step and Set function.

2 Press the Cursor Up ∧

∧∧

∧ button to begin Step and Set. The selected mode button will turn off.

If no setup code is currently programmed for the selected mode, the search begins with the

most popular setup code for the selected device. If a setup code has been previously

programmed, the search begins with the next setup code for that device.

3 Use the following buttons to determine if the setup code properly operates the selected

device:

 Number buttons 0, 1, 2, or 3 (use to test TV setup codes)

 Channel Up (use to test TV setup codes)

 Play (use to test VCR setup codes)

 Rewind (use to test VCR setup codes)

4 If the setup code successfully operates the device, press OK on the remote control. The setup

code is now programmed into your remote control.

If the setup code does not operate the device, repeat steps 2 and 3.

During Step and Set, if there is more than a ten second pause between pressing buttons on the

remote control, the remote will exit Step and Set and return to the previously programmed

setup code.

You can only set up your remote control while in TV, VCR 1 or VCR 2 mode.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 140 141

No comments

Motorola DCP 501 User Manual Page 31